2013 Ford F-150
Mileage
114,569
Service Date
3/4/2024
Services Performed
- – Test drove vehicle and found the transmission has a noisy whine. – PO722-00 Output shaft speed sensor circuit (No signal) – On test drive noticed speedometer read 0 mph. – Shortly after, transmission would engage into first gear. – Checked for misfire counts. No misfires at this time. – Tested OSS signal wire has continuity. – Racked vehicle to check fluid level and condition, Fluid is very dirty and burnt. – Used testing equipment to test the output shaft sensor. The wave forms were extremely erratic, these readings usually indicate a damaged reluctant ring. – Took a fluid sample from the transmission, fluid smelt burnt and was dirty, transmission makes a lot of noise. – Recommend new transmission.
- TRANSMISSION OIL PAN &/OR GASKET – Remove
- TRANSMISSION OIL PAN &/OR GASKET – Remove & Replace
- TRANSMISSION ASSEMBLY – Remove & Replace – V6,4WD
- (Additional) – TRANSMISSION ASSEMBLY – Remove & Replace w/Skid Plate
- – Hook up re flash equipment – Connect to the data base, down load the program To install into the new computer. – Retest after completing the re flash to confirm it is working as it should.
- (Combination) – OIL COOLER LINES – Flush
- (Combination) – FRONT PUMP SEAL – Remove & Replace
- (Combination) – TORQUE CONVERTER – Remove
- EXTENSION HOUSING SEAL – Remove & Replace – 4WD – [Includes: R&I Transfer Case Assembly. Includes: Scan Tool and Road Test.]
- TRANSMISSION OIL FILTER – Remove & Replace
- TRANSFER CASE OIL SEAL – Remove & Replace – Rear,Output
- TRANSFER CASE OIL SEAL – Remove & Replace – Front,Input – [Includes: R&I Transfer Case Assembly.]
Leo G. gave our service a 5 star review on 3/4/2024
