BEGIN: BBB AB Seal

END: BBB AB Seal

JSON-LD markup generated by Google Structured Data Markup Helper.

Call (360) 629-9527

Go to…

Ford

Home / Ford

We Service and Repair all Ford cars

  • 2006 Ford Mustang

    Ford Mustang
    Mileage
    170,519
    Service Date
    2/29/2024
    Services Performed
    • Diagnose- -**** Shiver/misfire intermittently, lost power..
    • SPARK PLUGS – Remove & Replace – V6
    • SPARK PLUG WIRE SET – Remove & Replace
    • CATALYTIC CONVERTER – Remove & Replace – V6 Assembly
    • OXYGEN SENSOR – Remove & Replace – O2 Sensor,One – [Includes: Component test.]
    • OXYGEN SENSOR – Remove & Replace – O2 Sensor,One – [Includes: Component test.]
    • OXYGEN SENSOR – Remove & Replace – O2 Sensor,One – [Includes: Component test.]
    • OXYGEN SENSOR – Remove & Replace – O2 Sensor,One – [Includes: Component test.]
    • Retest drive, scan computers & possibly more diagnoses? [ diag not included ]
    • Removed the muffler to Cleaned cat partical out of the muffler
     
    Jack B. gave our service a 5 star review on 3/7/2024

  • 2013 Ford F-150

    Ford F-150
    Mileage
    114,569
    Service Date
    3/4/2024
    Services Performed
    • – Test drove vehicle and found the transmission has a noisy whine. – PO722-00 Output shaft speed sensor circuit (No signal) – On test drive noticed speedometer read 0 mph. – Shortly after, transmission would engage into first gear. – Checked for misfire counts. No misfires at this time. – Tested OSS signal wire has continuity. – Racked vehicle to check fluid level and condition, Fluid is very dirty and burnt. – Used testing equipment to test the output shaft sensor. The wave forms were extremely erratic, these readings usually indicate a damaged reluctant ring. – Took a fluid sample from the transmission, fluid smelt burnt and was dirty, transmission makes a lot of noise. – Recommend new transmission.
    • TRANSMISSION OIL PAN &/OR GASKET – Remove
    • TRANSMISSION OIL PAN &/OR GASKET – Remove & Replace
    • TRANSMISSION ASSEMBLY – Remove & Replace – V6,4WD
    • (Additional) – TRANSMISSION ASSEMBLY – Remove & Replace w/Skid Plate
    • – Hook up re flash equipment – Connect to the data base, down load the program To install into the new computer. – Retest after completing the re flash to confirm it is working as it should.
    • (Combination) – OIL COOLER LINES – Flush
    • (Combination) – FRONT PUMP SEAL – Remove & Replace
    • (Combination) – TORQUE CONVERTER – Remove
    • EXTENSION HOUSING SEAL – Remove & Replace – 4WD – [Includes: R&I Transfer Case Assembly. Includes: Scan Tool and Road Test.]
    • TRANSMISSION OIL FILTER – Remove & Replace
    • TRANSFER CASE OIL SEAL – Remove & Replace – Rear,Output
    • TRANSFER CASE OIL SEAL – Remove & Replace – Front,Input – [Includes: R&I Transfer Case Assembly.]
     
    Leo G. gave our service a 5 star review on 3/4/2024

  • 2012 Ford Focus

    Ford Focus
    Mileage
    154,294
    Service Date
    9/11/2023
    Services Performed
    • – Idling in revers, there is a slit shudder. – On test drive the transmission has a erratic shift & feels to be slipping on acceleration. – Trans fluid is full. – Trans fluid is dirty & smells burned. – Front & rear brakes are looking good.
    • A/C COMPRESSOR DRIVE BELT – Remove & Replace – Normally Aspirated – [Includes: Serpentine type Belt(s).]
     
    Mike G. gave our service a 5 star review on 9/15/2023

  • 2005 Ford Freestyle

    Ford Freestyle
    Mileage
    192,326
    Service Date
    10/6/2021
    Services Performed
    • – Used jump box to get the vehicle in to the shop to diagnose the concern. – Once the vehicle was in the shop we hooked up battery charger. – Hooked up test equipment – Confirmed the alternator was Not charging – Charged the battery fully. – Retested charging system again confirmed the new alternator is working.
    • ALTERNATOR ASSEMBLY – Remove & Replace
     
    Mark H. gave our service a 5 star review on 10/13/2021

  • 2010 Ford Pickup

    Ford Pickup
    Mileage
    150,922
    Service Date
    1/20/2021
    Services Performed
    • Disconnect blower resistor. Connect new resistor and test. Works on all blower speeds. Install resistor and recheck. Working correctly at this time.
    • Remove resistor. Check for power to motor. Failed. Check power to resistor. Passed Check power out of resistor. Failed. Recommend replace resistor and retest. Customer approves. Check engine light on P0130 B1S1 O2 sensor P0150 B2S1 O2 sensor Oil change due
     
    John N. gave our service a 5 star review on 1/21/2021

  • 2009 Ford Explorer

    Ford Explorer
    Mileage
    105,307
    Service Date
    6/5/2020
    Services Performed
    • Air Conditioning system recover. Evacuate AC system Recharge AC with freon. Thermostat housing leaking bad. Coolant reservoir empty. Filled with antifreeze. Key fob does not work.
    • Remove dash panel. Remove AC control assembly. Install new AC control assembly. Install dash panel. Test function. AC low on freon. Retest after freon recharge. Working correctly at this time.
     
    Colin M. gave our service a 5 star review on 6/27/2020